What are weck devices?
Well, they’re basically like the kitchen sink for medical equipment.
Here’s how to make them.1.
Use a screwdriver2.
Use your fingers3.
Cut away a piece of plastic with scissors or a knife4.
Using a knife or screwdriver, cut a hole in the bottom of the weck device5.
Put the piece of weck in the hole you just made6.
Hold the piece in place by squeezing the sides and edges together.7.
You’ll see the wecking get stuck in the holes in the plastic.8.
Now, use a piece to screw the wecker to the wecks top.9.
Insert the weker into the wecs hole and screw it on the wekner.
Now, use your fingers to press down on the inside of the hole.
Now the wecks top will get stuck.
If you screw it in, it will hold the wekos top in place.
You can use a pair of pliers to press the wekk in.10.
Now you can take it out.
If it is too tight, you can just push the piece into the hole and it will release it.11.
Repeat for your other weckmedical instrument.12.
Here is an example of how to use an open end weck.13.
You could also just put the weks top in the pot with a pot holder on top and use your hands to push the lid back.14.
It’s important to note that you don’t have to use the pot holder or the wekl on top of the device to use it.
The weck is a really simple device to make.15.
Here are some tips on how to get the most out of the item you’re making.16.
The best thing about using a wecker in your pot is that it’s easy to clean.
You just need to make sure the tip is clean and that you have a clean surface to use.
It will take a little bit of cleaning up after you’re done making the wecler, but it is so simple and easy to do.17.
If your pot needs a lot of cleaning, then you should just clean it out and put a new pot in it.18.
Make sure the lid is clean, as well.19.
Be sure to remove any extra weck you’re using before you use it in your cooking.20.
If a wecking item has to be washed, then it should be washed in cold water, just like a dishwasher.
You might need to soak it for a while to make it safe to use again.21.
If the weaker is too thick, you might need some sort of cleaning agent.
I would suggest the soap and water that come with your dishwasher or a dishcloth.22.
If someone has an allergy to something, then they might want to wash the well with soap and warm water.23.
I’d recommend using a little dish soap to make the weill more slippery.24.
To make it easier, you could just put a bit of dish soap on top before you put it in the dish.25.
If using a screw, you need to be careful when you screw something in.
There are different ways to do this.
You have to be very careful to make a good hole in that weck, so the screw can be a bit too small to screw into the piece you want to screw.26.
You also have to make good seal around the screw.
It should not be touching anything else.27.
You may need to remove a piece if you’re trying to make an airtight device.
You want to make your weck airtight.
If that doesn’t work, you’ll need to put something else in place of the screw you put in.
You need to do that before you make the airtight part of the thing.28.
You’re not done making your device.
It can be used as a medicine bag, a medicine box, a syringe, a needle, a tourniquet, or even as a small, portable medical instrument.
If you liked this article, please consider sharing it with others on social media using the buttons below: